Kurzweil SP4-7 Instrucciones de operaciones descargar pdf (Pagina 13)

Getting Started

BeforeYouStart…

2-1

Chapter 2

Getting Started

This chapter will help you hook up your SP4 to your sound system and MIDI system. If

hooking up new gear is familiar to you, then simply read the following two sections in this

chapter. If you need more information, then be sure to read this chapter in its entirety.

Before You Start…

Don’t connect anything until you make sure your SP4 is properly and safely situated. If your

SP4 has been out in the cold, give it time to warm up to room temperature before starting it,

since condensation may have formed inside the SP4.

Quick Start

Make Connections

1. Set the keyboard on a hard, at, level surface.

2. Four adhesive-backed rubber feet are provided with your SP4. If you want to attach

them to the bottom of the SP4 (recommended to prevent scratching your tabletop),

carefully turn the keyboard over, remove the paper backing from the rubber feet and

attach them near each corner all on the same level.

3. Connect the power cable to the adapter then plug the adapter’s DC power cord into your

SP4. Finally, plug the power cable into the wall.

4. Make sure your sound system is at a safe volume level. Also make sure that the SP4’s

MASTER VOLUME slider (on the far left side of the front panel) is all the way down.

5. Plug in a pair of stereo headphones or run standard (1/4-inch) audio cables from

your ampliﬁer or mixer to the Audio Outputs on the SP4 (use the Left out for mono).

Balanced (“TRS” or “Stereo”) cables are recommended.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 117 118

Sin comentarios

Kurzweil SP4-7 Instrucciones de operaciones Pagina 13